1. Adjust the sound quality and volume. Because of the karaoke singing to KTV, the voice of the untrained person, the sound quality is not pure and lacks brightness, the male voice is prone to throat sound and hoarseness, and the female voice is prone to breath noise and arpeggio. Therefore, it is necessary to cut off the high frequency above 500MHz, and also need to be cut off below the low frequency of 100Hz, and increase the brightness by 3-6dB in the middle frequency band to increase the brightness and make the sound clear and bright. Generally, the singer's voice is low and lacks loudness, so the volume should be adjusted as much as possible. It is also possible to increase the frequency band around 2000MHz, so that the processing can also increase the sound level.
2. Adjust the ratio of the microphone volume to the accompaniment volume. Generally speaking, a good song, in terms of volume distribution, should be roughly 40c/o for accompaniment music and 60c/o for singing voice. If the singer is unfamiliar with the melody of the song, it is easy to sing the tune and not take the shot, then increase the accompaniment volume appropriately.
3. Beautify with reverberation. The characteristic of KTV singing is to add electronic reverberation to the singing voice, which can cover up some defects in the buzzing and vocalization. When a man whispers, he can generally shorten the reverberation time, and the soprano can properly extend the reverberation time to increase the color of the sound. As for the singing environment, if the wall around the room is made of wood, it has a reverberation effect. At this time, the reverberation time should be shortened to avoid blurring of the sound; in the case of no special requirements, it can be mixed. The adjustment knob is adjusted to the middle position, that is, the ratio of the direct sound component to the reverberation component is approximately 1:1.
4. KTV private room audio whistling tuning. If the high and low frequencies are prone to howling? It is not that the tuning is not in place, that is, the decoration has obvious obvious sound defects or both. At this time, you can try to properly attenuate the woofer of the microphone, keep the treble at 12 o'clock or raise it properly, then - slow - slow - raise the mic volume until there is a high frequency whistle and then properly call back to a safe volume position. Note that two microphones must be turned on at the same time, at least one should be placed on the table facing the speaker. I believe that you should get a clear and relatively safe microphone effect with easy sound. (The premise is that the whole set of equipment including the microphone has a relatively flat frequency response, in fact, it means to have better quality. If the hardware is congenitally insufficient, you don't have to work hard. The equipment is changed first.)
1. Adjust the sound quality and volume. Because of the karaoke singing to KTV, the voice of the untrained person, the sound quality is not pure and lacks brightness, the male voice is prone to throat sound and hoarseness, and the female voice is prone to breath noise and arpeggio. Therefore, it is necessary to cut off the high frequency above 500MHz, and also need to be cut off below the low frequency of 100Hz, and increase the brightness by 3-6dB in the middle frequency band to increase the brightness and make the sound clear and bright. Generally, the singer's voice is low and lacks loudness, so the volume should be adjusted as much as possible. It is also possible to increase the frequency band around 2000MHz, so that the processing can also increase the sound level.
2. Adjust the ratio of the microphone volume to the accompaniment volume. Generally speaking, a good song, in terms of volume distribution, should be roughly 40c/o for accompaniment music and 60c/o for singing voice. If the singer is unfamiliar with the melody of the song, it is easy to sing the tune and not take the shot, then increase the accompaniment volume appropriately.
3. Beautify with reverberation. The characteristic of KTV singing is to add electronic reverberation to the singing voice, which can cover up some defects in the buzzing and vocalization. When a man whispers, he can generally shorten the reverberation time, and the soprano can properly extend the reverberation time to increase the color of the sound. As for the singing environment, if the wall around the room is made of wood, it has a reverberation effect. At this time, the reverberation time should be shortened to avoid blurring of the sound; in the case of no special requirements, it can be mixed. The adjustment knob is adjusted to the middle position, that is, the ratio of the direct sound component to the reverberation component is approximately 1:1.
4. KTV private room audio whistling tuning. If the high and low frequencies are prone to howling? It is not that the tuning is not in place, that is, the decoration has obvious obvious sound defects or both. At this time, you can try to properly attenuate the woofer of the microphone, keep the treble at 12 o'clock or raise it properly, then - slow - slow - raise the mic volume until there is a high frequency whistle and then properly call back to a safe volume position. Note that two microphones must be turned on at the same time, at least one should be placed on the table facing the speaker. I believe that you should get a clear and relatively safe microphone effect with easy sound. (The premise is that the whole set of equipment including the microphone has a relatively flat frequency response, in fact, it means to have better quality. If the hardware is congenitally insufficient, you don't have to work hard. The equipment is changed first.)
1. Adjust the sound quality and volume. Because of the karaoke singing to KTV, the voice of the untrained person, the sound quality is not pure and lacks brightness, the male voice is prone to throat sound and hoarseness, and the female voice is prone to breath noise and arpeggio. Therefore, it is necessary to cut off the high frequency above 500MHz, and also need to be cut off below the low frequency of 100Hz, and increase the brightness by 3-6dB in the middle frequency band to increase the brightness and make the sound clear and bright. Generally, the singer's voice is low and lacks loudness, so the volume should be adjusted as much as possible. It is also possible to increase the frequency band around 2000MHz, so that the processing can also increase the sound level.
2. Adjust the ratio of the microphone volume to the accompaniment volume. Generally speaking, a good song, in terms of volume distribution, should be roughly 40c/o for accompaniment music and 60c/o for singing voice. If the singer is unfamiliar with the melody of the song, it is easy to sing the tune and not take the shot, then increase the accompaniment volume appropriately.
3. Beautify with reverberation. The characteristic of KTV singing is to add electronic reverberation to the singing voice, which can cover up some defects in the buzzing and vocalization. When a man whispers, he can generally shorten the reverberation time, and the soprano can properly extend the reverberation time to increase the color of the sound. As for the singing environment, if the wall around the room is made of wood, it has a reverberation effect. At this time, the reverberation time should be shortened to avoid blurring of the sound; in the case of no special requirements, it can be mixed. The adjustment knob is adjusted to the middle position, that is, the ratio of the direct sound component to the reverberation component is approximately 1:1.
4. KTV private room audio whistling tuning. If the high and low frequencies are prone to howling? It is not that the tuning is not in place, that is, the decoration has obvious obvious sound defects or both. At this time, you can try to properly attenuate the woofer of the microphone, keep the treble at 12 o'clock or raise it properly, then - slow - slow - raise the mic volume until there is a high frequency whistle and then properly call back to a safe volume position. Note that two microphones must be turned on at the same time, at least one should be placed on the table facing the speaker. I believe that you should get a clear and relatively safe microphone effect with easy sound. (The premise is that the whole set of equipment including the microphone has a relatively flat frequency response, in fact, it means to have better quality. If the hardware is congenitally insufficient, you don't have to work hard. The equipment is changed first.)
2. Adjust the ratio of the microphone volume to the accompaniment volume. Generally speaking, a good song, in terms of volume distribution, should be roughly 40c/o for accompaniment music and 60c/o for singing voice. If the singer is unfamiliar with the melody of the song, it is easy to sing the tune and not take the shot, then increase the accompaniment volume appropriately.
3. Beautify with reverberation. The characteristic of KTV singing is to add electronic reverberation to the singing voice, which can cover up some defects in the buzzing and vocalization. When a man whispers, he can generally shorten the reverberation time, and the soprano can properly extend the reverberation time to increase the color of the sound. As for the singing environment, if the wall around the room is made of wood, it has a reverberation effect. At this time, the reverberation time should be shortened to avoid blurring of the sound; in the case of no special requirements, it can be mixed. The adjustment knob is adjusted to the middle position, that is, the ratio of the direct sound component to the reverberation component is approximately 1:1.
4. KTV private room audio whistling tuning. If the high and low frequencies are prone to howling? It is not that the tuning is not in place, that is, the decoration has obvious obvious sound defects or both. At this time, you can try to properly attenuate the woofer of the microphone, keep the treble at 12 o'clock or raise it properly, then - slow - slow - raise the mic volume until there is a high frequency whistle and then properly call back to a safe volume position. Note that two microphones must be turned on at the same time, at least one should be placed on the table facing the speaker. I believe that you should get a clear and relatively safe microphone effect with easy sound. (The premise is that the whole set of equipment including the microphone has a relatively flat frequency response, in fact, it means to have better quality. If the hardware is congenitally insufficient, you don't have to work hard. The equipment is changed first.)
1. Adjust the sound quality and volume. Because of the karaoke singing to KTV, the voice of the untrained person, the sound quality is not pure and lacks brightness, the male voice is prone to throat sound and hoarseness, and the female voice is prone to breath noise and arpeggio. Therefore, it is necessary to cut off the high frequency above 500MHz, and also need to be cut off below the low frequency of 100Hz, and increase the brightness by 3-6dB in the middle frequency band to increase the brightness and make the sound clear and bright. Generally, the singer's voice is low and lacks loudness, so the volume should be adjusted as much as possible. It is also possible to increase the frequency band around 2000MHz, so that the processing can also increase the sound level.
2. Adjust the ratio of the microphone volume to the accompaniment volume. Generally speaking, a good song, in terms of volume distribution, should be roughly 40c/o for accompaniment music and 60c/o for singing voice. If the singer is unfamiliar with the melody of the song, it is easy to sing the tune and not take the shot, then increase the accompaniment volume appropriately.
3. Beautify with reverberation. The characteristic of KTV singing is to add electronic reverberation to the singing voice, which can cover up some defects in the buzzing and vocalization. When a man whispers, he can generally shorten the reverberation time, and the soprano can properly extend the reverberation time to increase the color of the sound. As for the singing environment, if the wall around the room is made of wood, it has a reverberation effect. At this time, the reverberation time should be shortened to avoid blurring of the sound; in the case of no special requirements, it can be mixed. The adjustment knob is adjusted to the middle position, that is, the ratio of the direct sound component to the reverberation component is approximately 1:1.
4. KTV private room audio whistling tuning. If the high and low frequencies are prone to howling? It is not that the tuning is not in place, that is, the decoration has obvious obvious sound defects or both. At this time, you can try to properly attenuate the woofer of the microphone, keep the treble at 12 o'clock or raise it properly, then - slow - slow - raise the mic volume until there is a high frequency whistle and then properly call back to a safe volume position. Note that two microphones must be turned on at the same time, at least one should be placed on the table facing the speaker. I believe that you should get a clear and relatively safe microphone effect with easy sound. (The premise is that the whole set of equipment including the microphone has a relatively flat frequency response, in fact, it means to have better quality. If the hardware is congenitally insufficient, you don't have to work hard. The equipment is changed first.)
1. Adjust the sound quality and volume. Because of the karaoke singing to KTV, the voice of the untrained person, the sound quality is not pure and lacks brightness, the male voice is prone to throat sound and hoarseness, and the female voice is prone to breath noise and arpeggio. Therefore, it is necessary to cut off the high frequency above 500MHz, and also need to be cut off below the low frequency of 100Hz, and increase the brightness by 3-6dB in the middle frequency band to increase the brightness and make the sound clear and bright. Generally, the singer's voice is low and lacks loudness, so the volume should be adjusted as much as possible. It is also possible to increase the frequency band around 2000MHz, so that the processing can also increase the sound level.
2. Adjust the ratio of the microphone volume to the accompaniment volume. Generally speaking, a good song, in terms of volume distribution, should be roughly 40c/o for accompaniment music and 60c/o for singing voice. If the singer is unfamiliar with the melody of the song, it is easy to sing the tune and not take the shot, then increase the accompaniment volume appropriately.
3. Beautify with reverberation. The characteristic of KTV singing is to add electronic reverberation to the singing voice, which can cover up some defects in the buzzing and vocalization. When a man whispers, he can generally shorten the reverberation time, and the soprano can properly extend the reverberation time to increase the color of the sound. As for the singing environment, if the wall around the room is made of wood, it has a reverberation effect. At this time, the reverberation time should be shortened to avoid blurring of the sound; in the case of no special requirements, it can be mixed. The adjustment knob is adjusted to the middle position, that is, the ratio of the direct sound component to the reverberation component is approximately 1:1.
4. KTV private room audio whistling tuning. If the high and low frequencies are prone to howling? It is not that the tuning is not in place, that is, the decoration has obvious obvious sound defects or both. At this time, you can try to properly attenuate the woofer of the microphone, keep the treble at 12 o'clock or raise it properly, then - slow - slow - raise the mic volume until there is a high frequency whistle and then properly call back to a safe volume position. Note that two microphones must be turned on at the same time, at least one should be placed on the table facing the speaker. I believe that you should get a clear and relatively safe microphone effect with easy sound. (The premise is that the whole set of equipment including the microphone has a relatively flat frequency response, in fact, it means to have better quality. If the hardware is congenitally insufficient, you don't have to work hard. The equipment is changed first.)
Guangzhou Yunge Tianhong Electronic Technology Co., Ltd , https://www.e-cigarettesfactory.com