A 200W solar photovoltaic grid-connected inverter design solution can directly convert the DC power generated by the solar panel into a 220V/50Hz power frequency sinusoidal AC output to the grid.
A control system for a low-power photovoltaic grid-connected inverter: The topology of the DC/DC controller adopts a push-pull circuit, which is controlled by a chip SG3525, which effectively prevents bias, DC/AC inverter The device is a full-bridge inverter circuit, which is controlled by DSP. Because the computing speed of the DSP is relatively high, the output current of the inverter can well track the grid voltage waveform. The effectiveness of this photovoltaic grid-connected inverter control scheme was verified in the laboratory. The control system ensures that the output power factor of the inverter is close to 1, and the output current is sinusoidal.
System working principle and its control scheme
1 Photovoltaic grid-connected inverter circuit principle
The main circuit schematic diagram of the solar photovoltaic grid-connected inverter is shown in Figure 1. In this system, the solar panel outputs a rated voltage of 62V DC, which is converted to 400V DC by a DC/DC converter, and then 220V/50Hz AC is obtained after DC/AC inverter. The system ensures that the 220V / 50Hz sinusoidal current output by the grid-connected inverter is synchronized with the phase voltage of the grid.
Figure 1 circuit block diagram
2 system control scheme
2 is a main circuit topology diagram of a photovoltaic grid-connected inverter, which is composed of a DC/DC converter of a front stage and a DC/AC inverter of a subsequent stage. The inverter circuit of the DC/DC converter can be selected from the group consisting of a half bridge type, a full bridge type, and a push pull type. Considering that the input voltage is low, if the half-bridge type is used, the switching tube current becomes larger, and the full-bridge type is complicated in control and the switching tube power consumption is increased. Therefore, a push-pull circuit is used here. The DC/DC converter is composed of a push-pull inverter circuit, a high-frequency transformer, a rectifier circuit and a filter inductor, and converts a 62V DC voltage output from the solar panel into a DC voltage of 400V.
Figure 2 main circuit topology
The main circuit of the DC/AC inverter adopts a full-bridge structure, which consists of four MOS tubes (parallel antiparallel diodes inside the tube), which converts 400V DC into 220V/50Hz power frequency AC.
2.1 DC / DC converter control scheme
Figure 3 Control block diagram of the DC/DC converter
Cylindrical Battery-Contacts And Clips
Cylindrical Battery Contacts Clips Springs
Antenk provides a wide variety of cylindrical battery contacts in various mounting styles
Antenk manufactures battery contacts, clips and springs for use with cases that have molded battery compartments, as well as for PCB mounting. These cost effective contacts allow a battery holder to be designed right into the body of the device while guaranteeing strong electrical connectivity with MPD's high quality battery contacts and springs. Antenk makes contacts and springs for use with all popular battery sizes, as well as some generic contacts for use with other types of cells.
Cylindrical Battery Contacts Clips Springs Features
Available in surface-mount, through-hole, and custom mounting options
RoHS 2 compliant
Used in conjunction with AAAA, AAA, AA, C, and D batteries
Battery Holder,Cylindrical Battery Contacts ,Cylindrical Clips,Cylindrical Contacts, Battery the Contacts,AAAA Contacts,AAA Contacts, AA Contacts, C Contacts
ShenZhen Antenk Electronics Co,Ltd , https://www.antenkcon.com