Industrial portable ultra-fine electronic endoscope using analytical

Industrial portable ultra-fine electronic endoscopes are not the same as traditional endoscopes when used. Special attention must be paid to the preparation before use.
1. Before using the electronic endoscope, check the tube: Before use, check whether the tube is abnormally deformed or broken.
Check the power: Turn on the power switch and press the C key on the control panel to check the power. If there is a battery alarm or low battery, turn off the power and charge. The charging time is 3~4 hours. If the indicator on the charger turns from red to green, the battery is fully charged.
Checking the lens: Look at the lens glass. If there is any foreign material and the surface is not clean, wipe it with cotton or lens paper.
If any of the above products are found to be abnormal, please send it back for repair!
2, the use of electronic mirrors ready to do a good job, everything is normal under the circumstances, began to use electronic mirrors, in order to ensure that the mirror can work properly, you need to straighten the mirror's insertion tube to bend after the operation!
Operation of the electronic mirror's limb: One hand holds the handle of the electronic mirror and the other hand holds the insertion tube.
Turn on the power, the machine works, the brightness of the front LED light source can be controlled by the buttons on the control panel. The front elbow is controlled by the thumb rotary dial. The viewing angle of the display can be adjusted by turning the display.
The instrument provides a video output signal that can be easily connected to an external display device such as a monitor. The image signal on the display device is the same as that on the 5.6" LCD screen. Please refer to Section 4 for the video recording operation.
3. After cleaning the electronic mirror, you should clean the electronic mirror according to the following methods.
Use a cotton swab dipped in alcohol to clean the dirty part of the surface of the electronic mirror; wipe the lens with a tissue paper.
4. The preservation of the electronic mirror keeps the electronic mirror box dry. Special attention should be paid to the use of a cotton swab to dry the surface of the lens after the first use. The storage area should be clean, dry, well ventilated, and maintain the normal temperature to avoid direct sunlight and high temperatures. , high humidity and X-rays.
5, electronic mirror repair If the electronic mirror can not work properly, please immediately cut off the power, packaged, and get in touch with the manufacturers! Do not open the shell without authorization, otherwise it will not be guaranteed!

MW01 Smart Watch

MW01 Smart Watch

Mw01 Smart Watch,Mw01 Smartwatch,Smart Watch Mw01,Smartwatch Mw01

everyone enjoys luck , http://www.eeluckwatch.com

Posted on