Smart home home theater cabling should pay attention to the problem

Home theater integrated wiring is divided into strong electrical wiring and weak electrical wiring. Power is generally referred to as the power cord. Home theater equipment requires high power. It is best to draw a few wires directly from the incoming line. The wiring of the power box of the audio-visual room should be separated from the outgoing line and the outgoing line, and separated and fixed according to the direction of the current and the size of the current.

Weak wires mainly include cable television lines, audio cables, audio cables, and telephone lines and network cables. The method of laying the weak wires is the same as that of the strong electricity, and the PVC pipe must be worn. It is better that the cross section of the wire does not exceed 40% of the cross section of the PVC pipe, and the strong wire and the weak wire must not be worn in the same pipe. And to try to separate, the distance between the strong wire and the weak wire is at least 20cm, otherwise there will be interference.

Also note the following two points:

The first is: To purchase high-quality wire rods, remember that bad quality lines cannot be used, and generally should be used to meet the normal use for 20 years;

The second is : floor speaker line should generally reserve 1.5m, do not only reserve 50cm, consider the equipment can take out and maintain.

If the speaker is hung on the wall or ceiling, the line will be 30-50cm long.

If you use a box sound or a bookshelf on a shelf, then the length of the line should preferably be 1.5 - 2m.

Speakers may have to move because of sound quality or the layout of the living room. Speaker line would rather cut and do not pick.